Kino-flo Image 80, 40 & 20 DMX Manual do Utilizador

Operation Manual DMX Image 80, 40, 20

Image 40 Lamp Sequence DMX Lamp Sequence Lamp # Dimmer LevelLamp 1 12 Lamp 1~2 37 Lamp 1~3 64 Lamp 1~4 83 Image 20 Lamp Sequence DMX L

For example, if the DMX IMAGE 80 base address is set at 001, the configuration below will provide eight lamps individually addressable through DMX51

XLR-515 DMX Cable 5 Pin, 15ft XLR-525 DMX Cable 5 Pin, 25ft BRD-I80 Image 80 Barndoors Set of 4 BRD-I40 Image 40 Barndoors Set of

2. Press the tabs of both brackets into the square receptacles. 3. Slide the two brackets up until the silver lock pin snaps into place. 4. To r

Adjust the hinge tension with a Philips head screwdriver. 14 Kas-I80-1 Kas-I80-2

Model: DMX Image 80 Power requirements: 120VAC or 230VAC Amperage: 8.6 amps at 120VAC, 4.3 amps at 23

Environmental: Disposal of Old Electrical & Electronic Equipment. 16

DMX Image 80 • 8 x 4ft lamps • DMX and Manual on/off switching control • Switches one lamp at a time DMX Image 40 • 4 x 4ft lamps •

Insert lamps into both lamp holders. Twist ¼ turn to make electrical contact. The gel frame is secured to the fixture by 4

Place the long edge of the Louver into the lower channel containing a set of leaf springs. Press down on the Louver and slip the upper edge

The Image 80 Fixture is used for example purposes throughout these instructions. 5

Provide 120 Volt AC primary power. Do not dim the fixture through a dimming circuit. If powering the fixtures through a dimmer board,

DMX Image 20 Switching Note: Manual lamp switching is disabled as soon as DMX cables are applied. 7

The DMX Terminate Switch must be set to open ( O ) on Fixtures within the DMX chain. Set to closed ( I ) when the Fixture is the last DMX control d

Setting the unit to "Fixture Mode" allows the user to re-create the "Inside-Out" pattern of the manual switch. One of t